Esstac 20 Gauge Shotgun Card
7 rounds of 20 gauge ammunition can be carried on this shotty card, which is backed with hook. Line the side of your receiver with loop, and you have an ammo "side-saddle" system that you can replace in an instant. The versatility of these Shotgun Cards will prove themselves many times over the more you use them!
Dimensions: 6.25" x 2"
Note from Stu @ Esstac about the elastic loop longevity:
"Shotty cards, treat them like a magazine. They will wear more quickly with use rather then just sitting loaded, they will lose some tension over time but that is normal for elastic, I have a couple ammo cans full of loaded shotgun cards and they are still GTG several years later."
Related Products
Reviews
-
Must have
Great product! Holds 20g shells perfect!
-
Mmm gear
6-1/4" long. Fits perfectly between the front edge of the frame and the trigger pin on a 20 gauge 590. Recommend trimming the rear lower corner of the shotgun card because it is sharp and touches your index finger when shooting lefty. Pull loop was a little longer than needed, so tied a knot in it. Great product, shot shell loops are super tight when new(maybe too tight). Hope this helps. As always skd service is great.
-
Purpose built win!
Finally, a shotshell card specifically for 20 gauge.
-
Great service and product
Happy with our order and they work like we had hoped.
-
shotgun card
great site, great service...ordering was fast and easy...only place i could find a 20 gauge shotgun card...they're both mounted and work fine...definitely 5 stars...will order again
-
Just what I Needed
The construction is great, the price was great and it fits on my 870 as I had hoped.
-
Great fabric
Velcro is nice and tight. Holds 20 gauge shells perfectly.
-
Value
Awesome quality
-
20 ga Shotgun Card does not fit 20 ga
I have a Mossberg 500 20 ga...ordered the 20 ga card, which is configured for 6 shells...with advice from Tracy, I cut off 2 of the shell loops and now have a 4 shot card...better than a no shot card...gun would not operate without the aforementioned....with the fabrication, the receiver will now cycle....what the heck, for $13, I now have more backup than I did before...Fab was easy...